![]() ![]() SSL/IKE microcode : CNlite-MC-SSLm-PLUS-2.08 Hardware: ASA5505, 512 MB RAM, CPU Geode 500 MHz,Įncryption hardware device : Cisco ASA-5505 on-board accelerator (revision 0x0) System image file is "disk0:/asa924-13-k8.bin" If you do not know your gateway, you can easily find it by entering your IP and netmask on this site.Ive just got the console cable, now i can show you the results of "sh version":Ĭisco Adaptive Security Appliance Software Version 9.2(4)13Ĭompiled on Wed 22-Jun-16 10:03 by builders route outside 0.0.0.0 0.0.0.0 X.X.X.X 1Īs before, substitute your gateway value for X.X.X.X.If you don't have an "obj_any" use the 0.0.0.0 0.0.0.0 values. Finally, "obj_any" represents the IP address of 0.0.0.0 and the netmask of 0.0.0.0. Older versions of ASDM are similar, but may require some adaption. Second, these instructions are based on ASDM 7.3(1). First, substitute your ISP gateway value for X.X.X.X. Press OK, Apply, and Save, respectivelyĪ few notes.Select: IP Address Type: IPv4 Interface: Outside Network: obj_any Gateway IP: X.X.X.X.Click the Add button (upper-right corner).Go Configuration->Device Setup->Routing->Static Routes.This is insanity-inducing because then no inside hosts can get to the Internet. ASA's do NOT set the ISP gateway through the startup wizard, even as of ASA 9.2(2).4. What's missing is the gateway information. Ewwhite's answer is correct but incomplete. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |